Atmel STK500 Uživatelský manuál

1Table of Contents TABLE OF CONTENTS...1 STK505 USER GUIDE ...

10Troubleshooting Guide Programming problems Problem Cause Solution ISP programming does not work ISP cable is not connected Connect a 6-pin cable

11General problems Problem Cause Solution Some of the port pins are not working. The AVR is not properly mounted in the ZIF socket. Make sure the ch

2STK505 User Guide Introduction The STK505 board is a top module to the STK500 development board from Atmel Corporation. It adds support for the 14-p

3Getting Started This section describes how to connect the STK505 onto the STK500, and connect cables to different peripherals. Hardware Overview T

4Mounting the STK505 The first thing you should do is to mount the STK505 onto the STK500. 1. Turn off the power on STK500. 2. Remove any other to

5Clock Sources and Reset The Clock Switch The STK505 has support to easily configure the hardware to support three different clock configurations •

6Programming the AVR Introduction There are two different ways of programming the AVR on STK505: 1. Low Voltage Programming (also called In-System P

7 Figure 2-2: In-System Programming of the ATtiny26 Note: To be able to ISP program the AVR, the ISP programming enable fuse must be set. The ISP

8 Figure 2-3: High voltage programming of the ATtiny24 Table 2-1: High-Voltage programming jumper settings for ATtiny24 STK500 VTARGET Mounted A

9 Figure 2-4: High voltage programming of the ATtiny26 Table 2-2: High-Voltage programming jumper settings for the ATtiny26 STK500 VTARGET Moun